Recording the measuring point
The measuring point or installation to be tested is examined for damage, deposits, and assembly geometry.
Function test
The correct function of the existing measuring point is evaluated. The measurement data are recorded so that they are available for comparison with the test measurement.
Control measurement
The existing measuring point is checked for plausibility with a mobile second installation. The correct measurement data acquisition is ensured by adjusting the relevant parameters in the field. If possible, a control installation is used, which has a higher measuring accuracy than the existing one, to be able to determine the measuring error as accurately as possible.
Documentation and results
The control measurements are fully documented. A measurement protocol with all measurement data is handed over to the customer as proof.
Services
- Checking of all types of flow measurements and whether the correct measuring method has been installed.
- Nominal pipe sizes from DN15 to DN2000
- Pipe material independent (steel, stainless steel, cast iron, plastic, concrete, eternit, etc.)
- Accuracy range depends on the measuring point, usually approx. 1%.
- Verification measurements of existing flow measurements
- Measurement of unmonitored network segments
- Performance verifications for pumps
- Flow direction checks
- Preparation of a measurement report for each measuring point
